Westerbeke 4.5 KW BGC -60Hz Manual del operador descargar pdf (Pagina 85)

Batteries

If batteries are

left on board during the lay-up period, make sure they are fully charged, and will remain

that way,

prevent them from freezing. If there exists any

doubt

that the batteries will not remain fully

charged,

that they will be subjected to severe environmental conditions, remove the batteries and store

them in a warmer, more compatible environment.

Recommissioning

The recommissioning of your Westerbeke unit after a seasonal lay-up generally follows the same proce-

dures as those presented in the "PREPARATIONS

FOR

STARTING" section, page

33,

regarding preparation

for starting and normal starts. However, some of the lay-up procedures will need

be counteracted before

starting the engine.

Remove the oil-soaked cloths from the intake manifold and from the through-hull exhaust port.

Remove the sea water

pump

cover and gasket. Discard the gasket. Install the sea water pump impeller

removed during lay-up (or a replacement, if required). Install the sea water pump cover with a new cover

gasket.

Wear rubber gloves, a rubber apron, and eye protection when servicing batteries.

Lead acid batteries emit hydrogen, a highly-explosive gas, which can be ignited

electrical

arcing

a lighted cigarette, cigar,

pipe. Do not smoke

allow an open flame near the

battery being serviced.

Shut off all electrical equipment in the vicinity

prevent electrical ar-

cing during servicing.

Reinstall the batteries that were removed during the lay-up, and reconnect the battery cables, making

sure the terminals are clean and that the connections are tight. Check

make sure the batteries are fully-

charged.

Check the condition

the zinc anode

the sea water circuit and clean

replace the anode as needed.

Note that it is not necessary to flush the antifreeze/fresh water solution from the sea water coolant

sys-

tem. When the

unIT

put into operation, the system will self-flush in a short period

time

WITh

ad-

verse affects.

Start the

unIT

in accordance with those procedures found in the "STARTING PROCEDURES" section

this manual, page

34.

Westerbeke

Generators

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 94 95

Comentarios a estos manuales

Sin comentarios

Westerbeke 4.5 KW BGC -60Hz Manual del operador Pagina 85

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Westerbeke 4.5 KW BGC -60Hz