Westerbeke 4.5 KW BGC -60Hz Manual del operador descargar pdf (Pagina 39)

STOPPING PROCEDURE

Remove the AC electrical load from the generator and allow the generator

run

for

5 minutes

sta-

bilize its operating temperatures.

Depress the STOP switch and hold it until the generator is completely stopped.

Now

release the STOP switch.

Break-In

Precautions

Because the generator set operates at 1800 rpm

produce 60 Hertz,

at 1500

rpm

produce 50 Hertz,

control of the generator's engine break-in is governed

the current

drawn

from the generator.

NOT

attempt

break-in

your

generator set

running it without a load.

Upon starting the generator set, check

for

proper operation. For the first 10 hours of the generator's opera-

tion, run the generator set between

20 and 60 percent of full-load.

After the first 10 hours

the generator's operation, the load may be increased

the rated full-load output.

Periodically vary the load.

Avoid overload at all times. An overload is signalled

a smoky exhaust, with reduced

output

voltage and

frequency. Monitor

the

current being drawn from the generator and keep it within the generator's rating.

Be aware of

motor

starting

loads

and the high current draw required

for

starting

motors

(see page 64

for

"Amps

for

Starting" chart).

Starting

Under

Normal

Conditions

Follow the procedure

below

for

routine starting of the generator:

Check the engine's

lubricating oil level prior

each

day's

use. Add oil as needed and maintain the oil level

at the high mark on the dipstick.

Check the

coolant level in the plastic recovery tank.

NOTE: Excessive loss

fresh water coolant from the plastic recovery tank indicates a

cool-

ing system leak. Check the entire cooling system; pressurize the system

locate the leak.

cases

excessive coolant loss, the system must be refilled as outlined under the

"PREPARATIONS FOR STARTING" section of this manual, page 33.

Visually examine the unit;

look

for

any

abnormalities and correct them as needed.

Check

make sure there is sufficient fuel

the tank and examine the filter/separator bowls

lor

contaminants.

Clean and drain the bowls as needed.

Start the generator, following the procedure outlined in the "STARTING PROCEDURES" section, page 34,

and

allow the engine's operating temperature

reach 130

-150'

F (55 -

66'

C) before placing the generator

under a heavy

load.

Westerbeke

Generators

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 94 95

Comentarios a estos manuales

Sin comentarios

Westerbeke 4.5 KW BGC -60Hz Manual del operador Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Westerbeke 4.5 KW BGC -60Hz