Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 62)

Component Removal and Replacement

R560 – Thermal Snap Switch

Table of Contents

Verify that the battery is reinstalled into the PLS in order for the engraver

to function properly.

Use caution when installing the new Thermal Snap Switch. Do not apply

excessive force when bending the Thermal Snap Switch’s metal

contacts.

1. Make sure the PLS is powered OFF and unplugged.

2. Remove the Thermal Sensor Board’s battery holder by inserting a flat head screw

driver into the slot of the battery holder. Gently push up then pull the screw driver

towards yourself to remove the battery holder and set it aside.

3. Open the top door and located to the

back wall of the PLS is the Thermal

Sensor cover. Unscrew the 2 screws

and set them aside.

4. Disconnect the Crimp Lugs that are

connected to the Thermal Snap

Switch.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 62