Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 21)

Adjustments and Settings

Note: To create a small burn mark on the tape in the next step you will need to adjust

your Power and Seconds settings in the Alignment Mode screen (lower left side).

Lower power laser tubes require higher power settings and higher power laser tubes

require lower power settings to make the burn mark on the tape.

15. Once the red diode is centered adjust

the Power and Seconds settings on

the lower left side of the Alignment

Mode window. Start of with 5%

Power and 2 Seconds.

16. Close the top door if it’s not already

closed and then click on the Activate

Laser button.

• If a burn mark is not made

continue to modify the Power and

Seconds settings.

17. If the burn mark is not centered use a new piece of tape and adjust the

corresponding screw in small turns on the #2 Mirror mount until the burn mark is

centered.

• Keep in mind that you can use the red diode as a guide.

18. If the burn mark is centered continue to the next step.

19. Once the burn mark is centered keep the piece of tape on the focus carriage.

20. Now click on the lower right side

Move button.

21. Close the top door if it’s not already

closed and then click on the Activate

Laser button. Take note of the burn

mark.

22. Both burn marks should be over lapping each other. If they are not continue to

adjust the #2 Mirror for the lower right hand corner.

23. Once aligned Exit the Alignment Mode Window and remove the masking tape from

the Focus Lens Carriage and reinstall the optics.

24. Power off and unplug the PLS.

25. Reinstall the cover and two screws over the #2 mirror mount from step 10.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 21