Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 41)

Component Removal and Replacement

7. Insert the new Y-Axis Belt ends into

the belt clamp with the belts teeth

facing inward. The Y-Axis belt in

the following image was twisted

for reference only.

8. Once the belt is attached to the belt clamp you will need to tension it. Located on

both ends of the Y-Axis rails are Idler Pulleys (1). To tension the Y-Axis belt turn

BOTH tensioning screws on the Y-Axis rail the same amount.

9. Installation is opposite of removal.

10. Once everything back in place you need to square the X-Axis Arm (X-axis Arm

Alignment Check and Adjust).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 41