Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 6)

Adjustments and Settings

A000 – Safety – PLEASE READ!

Table of Contents

Description of Appropriate Use

This device is designed for laser cutting and engraving of the materials listed in the PLS

printer driver. Materials to be processed must fit completely inside the system for

proper operation. Use of the equipment in a manner other than that described in this

manual may result in injury to yourself and others and may cause severe damage to the

equipment and your facility.

General Safety

• Exposure to the laser beam may cause physical burns and can

cause severe eye damage. Proper use and care of this system are

essential to safe operation.

• Never operate the laser system without constant supervision

of the cutting and engraving process. Exposure to the laser

beam may cause ignition of combustible materials and start a fire.

A properly maintained fire extinguisher should be kept on hand at

all times.

• Never leave materials in the laser system after laser processing

has finished. Materials may ignite after laser processing has

finished. Thoroughly inspect the interior of the laser system and

remove any particulate materials before leaving your workstation. A

properly maintained fire extinguisher should be kept on hand at all

times.

• A properly configured, installed, maintained, and operating particulate/fume

exhaust system is mandatory when operating the laser system. Fumes and

smoke from the engraving process must be extracted from the laser system and

either filtered through the Integrated Exhaust Filtration Module (an optional

accessory) or exhausted outside through a user supplied exhaust system.

• Some materials, during and after laser processing, may

produce toxic fumes. We suggest that you obtain the Material

Safety Data Sheet (MSDS) from the materials manufacturer. The

MSDS discloses all of the hazards when handling or processing

that material. Some materials continue emitting fumes for several

minutes after laser processing and may pose a health hazard. Avoid using this

device in small, enclosed, or non-ventilated areas.

• Some materials, during and after laser processing, may produce

corrosive fumes. DISCONTINUE processing any material that

produces signs of chemical deterioration in the laser system such as

rust, metal etching or pitting, peeling paint, etc. Damage to the laser

system from corrosive materials is NOT covered under warranty.

1 2 3 4 5 6 7 8 9 10 11 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 6