Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 51)

Component Removal and Replacement

5. Unplug all 3 connectors from the

board.

6. When installing the new board verify

that the 2 white nylon standoffs (pegs)

(only one shown) are placed into the

slotted sheet metal.

7. After the new board has been installed you will need to re-calibrate all the lens you

have, the cutting table (if applicable), and rotary (if applicable) using the UCP’s

System Tab.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 51