Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 19)

Adjustments and Settings

3. Place a strip of masking tape over the

hole on the left side of the Focus

Carriage.

4. The red diode beam should appear

on the tape. The red diode beam

should be fairly centered over the

hole.

5. Using the Focus Feature (1) of the Viewer Tab in the UCP, verify the position of

the red diode beam relative to the hole in the focus carriage in all four corners of

the table.

6. The red diode should be fairly centered on the hole in all four corners of the table. If

this is the case, you can remove the masking tape from the hole in the focus

carriage and reinstall the optics. The red diode is aligned.

7. If the red diode beam is not centered on the hole in all four corners of the table, the

beam will need to be aligned. Do not remove the masking tape or reinstall the optics.

8. Power off the PLS and unplug the unit.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 19