Westerbeke 120D-TWO Manual de usuario descargar pdf (Pagina 16)

Adjustments and Settings

A050 - X-axis Arm Alignment Check and Adjust (Squaring)

Table of Contents

1. Power off the PLS and unplug it.

2. Remove the #2 mirror cover (1) by

removing the thumbscrew (2), sliding

the cover to the right and then off the

rail.

3. Grasp the X-axis arm and slowly pull the arm towards you until it stops.

4. Observe if the left side and right side of the X-axis arm makes contact with the left

and right side shoulder screws, at the same time, respectively.

5. If there is a gap between the shoulder screw and the contact point on either the left

or right side of the arm, you will need to square the arm by making an adjustment.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

Sin comentarios

Westerbeke 120D-TWO Manual de usuario Pagina 16