
3.
Reinstall
the batteries that
were
removed
during the
lay-up,
and
reconnect the battery
cables,
making
sure
the terminals
are
clean
and
that the connections
are
tight. Check to
make
sure
that the batteries
are
fully-charged.
4.
Check the condition of the zinc anode
in
the
sea
water circuit
and
clean or replace the anode
as
needed.
Note that it
is
not necessary to flush the antifreeze/fresh water solution from the
sea
water coolant
sys-
tem.
When
the engine
is
put into operation, the
system
will self-flush
in
a short period of time with no ad-
verse affects.
5.
Start the engine
in
accordance with procedures
in
the
"PREPARATIONS
FOR
STARTING"
section of this
manual,
page
32.
Westerbeke Generators
78
Comentarios a estos manuales