Westerbeke 20B TWO Manual de instalación Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 72
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
DOMESTIC
HOT
WATER
TANK
CONNECTIONS
HOT
WATER
HEATER
ABOVE
THE
ENGINE
If
any portion
of
the heating circuit rises above the engine's
PRESSURE
CAP
IS
RATED
own pressure cap, the a pressurized (aluminum) remote
LOWER
THAN
MANIFOLD
CAP
expansion tank must be installed in the circuit to become the
highest point. The remote expansion tanks part number is
24177. Tee the remote expansion tank into the heater circuit
at the heater connection, choosing the higher
of
the two for
the return. Tee right at the heater and plumb a single line up
to the tanks location and the other back to the engine's flow
control. Install the remote expansion tank in a convenient
location such as in a sail locker so the fresh water coolant
level can easily be checked. The remote expansion
tank
will
now serve as a check and system fill point. The plastic
coolant recovery tank is not used when the remote expansion
tank kit is installed, since this tank serves the same function.
HEATER
COILS
ABOVE
The pressure cap on the engine's manifold should be
installed once the engine's cooling system
is
filled with
coolant. Finish filling the cooling system from the remote
tallk once the system is filled and is free
of
air and exhibits
good coolant circulation. During engine operation, checking
the engine's coolant should be done at the remote tank and
not at the engine manifold cap.
The hose connection from the heater to the remote
expansion tank should be routed and supported so as to rise
continuously from the heater to the tank, enabling any
air in
the system to rise.
23
PRESSURE
CAP
ON
ENGINE
MANIFOLD
..
\ I
REMOVE
THE
8-~~~~-SS
HOSE
J.
' I
~.)
HEATER
ABOVE
ENGINE
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 71 72

Comentarios a estos manuales

Sin comentarios