Westerbeke 20B TWO Manual de instalación descargar pdf (Pagina 14)

PREPARATIONS

FOR

INITIAL

START-UP

PRESTART

INSPECTION

Before starting your engine for the first time or after a

prolonged layoff, check the following items:

0 Check the engine oil level. Add oil to maintain the level

at the high mark on the dipstick.

0 Tum on the fuel supply, then check the fuel supply and

examine the fuel filter/water separator bowl for

contaminants.

0 Check the transmission fluid level.

0 Check the

electrical system. Inspect wire connections

and battery cable connections. Make certain the positive

( +) battery cable is connected to the starter solenoid and

the

negative(-)

cable is connected to the engine ground

stud (this location is tagged).

0 Check the coolant level in both the plastic recovery tank

and at the manifold.

CHECK

COOLANT

LEVEL

NOTE:

the engine has not yet been filled with coolant,

refer to the

COOUNG

SYSTEM section

this manual.

0 Visually examine the engine. Look for loose or missing

parts, disconnected wires, and unattached hoses. Check

the threaded connections and engine attachments.

D Make certain there is proper ventilation around the

engine.

ample supply is necessary for proper engine

performance.

0 Make sure the mounting installation is secure.

0 Ensure the propeller shaft is securely attached to the

transmission.

0 Open the thru-hull and make certain raw water is primed

to the raw water strainer.

DIPSTICK

CHECK

ENGINE

OIL

LEVEL

FULL

LOW

Engines & Generators

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

Comentarios a estos manuales

Sin comentarios

Westerbeke 20B TWO Manual de instalación Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Westerbeke 20B TWO