PRODUCT SOFTWARE
Product software, (tech data, parts lists, manuals, brochures
and catalogs) provided from sources other than
WESTERBEKE are not within WESTERBEKE’s control.
WESTERBEKE CANNOT BE RESPONSIBLE FOR THE
CONTENT OF SUCH SOFTWARE, MAKES NO
WARRANTIES OR REPRESENTATIONS WITH RESPECT
THERETO, INCLUDING ACCURACY, TIMELINESS OR
COMPLETENESS THEREOF, AND WILL IN NO EVENT
BE LIABLE FOR ANY TYPE OF DAMAGE OR INJURY
INCURRED IN CONNECTION WITH OR ARISING OUT
OF THE FURNISHING OR USE OF SUCH SOFTWARE.
WESTERBEKE customers should also keep in mind the
time span between printings of WESTERBEKE product
software and the unavoidable existence of earlier
WESTERBEKE manuals. In summation, product software
provided with WESTERBEKE products, whether from
WESTERBEKE or other suppliers, must not and cannot be
relied upon exclusively as the definitive authority on the
respective product. It not only makes good sense but is
imperative that appropriate representatives of
WESTERBEKE or the supplier in question be consulted to
determine the accuracy and currentness of the product
software being consulted by the customer.
NOTES, CAUTIONS AND WARNINGS
As this manual takes you through the installation procedures
for your engine/generator, critical information will be high-
lighted by NOTES, CAUTIONS, and WARNINGS. An
explanation follows:
NOTE: An operating procedure essential to note.
INSPECTION OF SHIPMENT
The engine/generator is shipped from the factory securely
mounted and properly crated. Accessory equipment is
shipped in a separate small box, usually packed within the
engine’s crate.
Before accepting shipment of the engine from the
transportation company, the crate should be opened and the
contents inspected for damage. If there is either visible or
concealed damages, you should require the delivery agent to
write “Received in damaged condition” on the delivery
receipt. Also compare the contents of the shipment against
the packing list and make sure that any discrepancies are
properly noted. This is your protection against loss or
damage. Claims concerning loss or damage must be made to
the carrier, not to WESTERBEKE Corporation.
NOTE: For safety reasons, the engine is NOT filled with
lubricating oil for shipment. Before leaving the factory,
however, each engine/generator is thoroughly tested with oil
in its engine. This testing, among other things, provides all
internal parts with a coating of oil. This oil acts as a
preservative, providing reliable protection against corrosion
for at least one year if the engine/generator is properly
stored.
3
INTRODUCTION
▲ CAUTION:
Procedures which, if not strictly
observed, can result in the damage or destruction of
your engine.
▲ WARNING:
Procedures which, if not properly fol-
lowed, can result in personal injury or loss of life.
Comentarios a estos manuales