Westerbeke 15.0KW -60Hz EDT Manual del operador descargar pdf (Pagina 88)

100

Batteries

II batteries

are

be left on board during the lay-up period, ensure

lha!

they are and will remain

that way,

prevent them from freezing.

there exists any doubt Ihat the batteries will not remain lully

charged,

that they will

subjected

severe environmental conditions, remove the batteries and store

them

a warmer, more compatible environment

Recommissioning

The recommissioning of your Westerbeke unit after a seasonal lay-up generally follows the same proce-

dures

those presented

the "PREPARATIONS

FOR

STARTING"

section, page 35, regarding preparation

for starting and normai starts. However, some

the lay-up procedures will need

counteracted before

starting the engine.

Remove the oil-soaked cloths lrom the intake manifold and from the through-hull exhaust port.

2. Remove the sea water pump cover and gasket. Discard the gasket. Install the sea water pump impeller

removed during lay-up (or a replacement, if required). Instalilhe sea waler pump cover with a new cover

gasket.

iWARNINGI

Wear rubber gloves, a rubber apron, and eye protection when servicing batteries.

Lead

acid batteries emit hydrogen, a highly-explosive gas, which can be ignited

electrical

arcing

a lighted cigarette, cigar,

pipe. Do not smoke

allow an open flame near the

battery being serviced.

Shut off

all

electrical equipment in the vicinity

prevent electrical ar-

cing during servicing.

Reinstall the batteries that were removed during the lay-up, and reconnect the battery cables, making

sure the terminals

are clean and that the connections are tight. Check

ensure that the batteries are

fully-charged.

Check the condition of the zinc anode in the sea water circuit and clean

replace the anode as needed.

Note that it is not necessary

flush the antifreeze/fresh water solution from the sea water coolant sys-

tem. When the unit

put into operation, the system will self-flush in a short period

time wtth no ad-

verse affects.

Start the unit in accordance with those procedures found in the "STARTING PROCEDURES" section of

this manual, page

36.

Westerbeke Generators

!l4

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 99 100

Comentarios a estos manuales

Sin comentarios

Westerbeke 15.0KW -60Hz EDT Manual del operador Pagina 88

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Westerbeke 15.0KW -60Hz EDT