
1.
Visual access to the
fuel
injection pump's
fuel
rack is needed. To obtain this, remove the small square
side
coverlbracketry just below the fuel injection pump. This
is
shown
as
cover part #037045 and gasket
#036981 in the parts
list
2.
Thread the locknut #034669 onto the solenoid and then apply a small amount
of
Teflon sealant to the
threads on the solenoid.
3.
Thread the solenoid into the boss on the engine and observe the solenoid plunger through the cover
opening. Allow the plunger to contact the fuel rack and move it fully into the injection
pump. Do not
thread further
so
as to push the plunger into the solenoid.
4.
Back the solenoid out
114
-
112
of
a tum and secure it in position with the locknut
5.
Properly connect the three electrical leads from the solenoid. Two
of
the connections plug into the
engine harness and the third grounds
to
the engine block at an adjacent inboard threaded boss with an
8mmbolt
6.
Reassemble the coverlbracketry and test run the
unit
Ensure that the unit stops when the solenoid is
de-energized.
1.
FUE"
SHUT
OFF
SOLENOID
#037100
2.
LOCKNUT
#034569
3.
SOLENOiD
?LUNGER
69
WESTERBEKE GENERATORS
Comentarios a estos manuales